EasyManua.ls Logo

Braun 5694 - Using the Shaver and Charging (English); Shaving Techniques and Customization (English)

Braun 5694
33 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
27
Charging information
A full charge will take about 1 hour and provides up to 50 minutes of cordless
shaving time. This may vary according to your beard growth and environmental
temperature. 5-minute quick charge is suffi cient for a shave.
Recommended ambient temperature for charging is 5 °C to 35 °C. The battery
may not charge properly or at all under extreme low or high temperatures.
Recommended ambient temperature for shaving is 15 °C to 35 °C. Do not expose
the shaver to temperatures higher than 50 °C for extended periods of time.
Using the shaver
How to use
Press the on/off switch (12) to operate the shaver:
The pivoting shaver head and fl oating foils automatically adjust to every contour of
your face.
To shave hard to reach areas (e.g. under the nose), fi rst slide the shaver head to the
back position, afterwards move the head lock switch to the back. The pivoting head
is locked at this angle.
To trim sideburns, moustache or beard, slide the pop-out long hair trimmer
upwards.
Tips for the perfect dry shave
For best shaving results, Braun recommends you follow 3 simple steps:
1. Always shave before washing your face.
2. At all times, hold the shaver at right angles (90°) to your skin.
3. Stretch your skin and shave against the direction of your beard growth.
Personalizing your shaver
By holding down the accelerator button –/+ ( 13 ) or (14 ) you can adjust the shaving
power to your individual needs in the different areas of your face from sensitive to
intensive. The pilot light in the on/off switch (12) changes within the following range:
(–) sensitive shave
- light blue
- dark blue
- green
(+) intensive shave
For a thorough and fast shave we recommend the green (intensive) setting.
When switching on next time, the last used setting will be activated.
Shaving with the cord
If the shaver has run out of power (discharged), and you do not have the time
to recharge it in the Clean&Renew station, you may also shave with the shaver
connected to an electrical outlet via the special cord set.
91508132_7760cc_JP.indd 2791508132_7760cc_JP.indd 27 24.07.17 15:2824.07.17 15:28
CSS APPROVED Effective Date 27Jul2017 GMT - Printed 04Sep2017 Page 27 of 34

Related product manuals