31
Shaving parts
have been
changed recently
but replacement
symbol lights up.
Reset button has not
been pushed.
– Push the reset button for at least
3 seconds to reset the counter.
Shaver head is
damp.
1. Drying time after
automatic cleaning
was too short.
2. Drain of the
Clean&Renew station
is clogged.
3. Cleaning cartridge
has been used for
quite a while.
1. Clean directly after shaving to allow
enough time for drying.
2. Clean the drain with a wooden
toothpick. Regularly wipe the tub clean.
3. The ethanol/isopropanol proportion has
decreased while the oil proportion has
increased. Remove residue with a cloth.
CLEAN&RENEW STATION
Cleaning does
not start when
pressing the
start button.
1. Shaver is not placed
properly in the
Clean&Renew station.
2. Cleaning cartridge
contains not enough
cleaning fluid (display
lights red).
3. Appliance is in
stand-by mode.
1. Insert shaver into the Clean&Renew
station (contacts of the shaver need to
align with contacts in the station).
2. Insert new cleaning cartridge.
3. Press start button again.
Increased
consumption of
cleaning fluid.
Drain of the
Clean&Renew station
is clogged.
– Clean the drain with a wooden
toothpick.
– Regularly wipe the tub clean.
91508132_7760cc_JP.indd 3191508132_7760cc_JP.indd 31 24.07.17 15:2824.07.17 15:28
CSS APPROVED Effective Date 27Jul2017 GMT - Printed 04Sep2017 Page 31 of 34
To Next Page
Loading...
