Braun 7680 - Clean&Charge Program Details and Management; Charge-Only Program Details; Corded Shaver Program Limitations; Starting and Controlling Programs

20
•«charge» (about 60 min)
• The corresponding lights will come on.
• (With cord shavers, only the «clean» function can be
selected.)
• Slide down the contact bow to connect the shaver and to
start the selected programme.
• If no programme is selected, the default function «clean»
will be started.
• Do not interrupt a running programme, as it leaves the
shaver wet and not fit for use. If interruption is needed
nonetheless, press the release button.
• After a programme has finished, the corresponding light
will go out. Prior to the next shave, press the release
button to release the shaver.
• When the «cartridge» light starts flashing, the remaining
fluid in the cartridge is sufficient for about 5 more cleaning
cycles. After these 5 cycles, the cleaning performance will
be reduced and the cartridge has to be replaced.
• When the «cartridge» light illuminates constantly, the
cleaning function is locked and a new cartridge has to be
installed.
Only then, the next cleaning cycle can be started.
• A cleaning cartridge should be sufficient for about 30
cleaning cycles. With daily use, the cleaning cartridge
should be replaced approx. every 4 weeks.
• The hygienic cleaning solution cartridge contains alcohol
which, once opened, will naturally evaporate slowly into
the surrounding air. Each cartridge, if not used daily,
should be replaced after approx. 8 weeks.
• Clean the housing from time to time with a damp cloth,
especially the opening where the shaver rests.
Subject to change without notice.
select
clean
char
ge
cartridge
5491391_7680_Korea Seite 20 Montag, 11. November 2002 2:42 14