Braun 7880cc - CLEAN&RENEW STATION; Cleaning does not start when pressing the start button.

14
Shaver head is
damp.
1. Drying time after automatic
cleaning was too short.
2. Drain of the Clean&Renew
station is clogged.
3. Cleaning cartridge has
been used for quite a while.
1. Clean directly after shaving to allow
enough time for drying.
2. Clean the drain with a wooden
toothpick. Regularly wipe the tub
clean.
3. The ethanol/isopropanol proportion
has decreased while the oil
proportion has increased. Remove
residue with a cloth.
CLEAN&RENEW STATION
Cleaning does
not start when
pressing the
start button.
1. Shaver is not placed
properly in the
Clean&Renew station.
2. Cleaning cartridge contains
not enough cleaning fluid
(display lights red).
3. Appliance is in stand-by
mode.
1. Insert shaver into the Clean&Renew
station (contacts of the shaver need
to align with contacts in the station).
2. Insert new cleaning cartridge.
3. Press start button again.
Increased
consumption of
cleaning fluid.
Drain of the Clean&Renew
station is clogged.
– Clean the drain with a wooden
toothpick.
– Regularly wipe the tub clean.
91845289_7880cc_7867cc_7865cc_7850cc_NA_S6-48.indd 1491845289_7880cc_7867cc_7865cc_7850cc_NA_S6-48.indd 14 14.03.18 10:5214.03.18 10:52
P&G AUTHORIZED 91869873 Rev 001 Effective Date 2018-03-20 Printed 2018-05-03 Page 14 of 48