49
Each cleaning program consists of several cycles, where
cleaning fluid is flushed through the shaver head.
Automatic cleaning
Start the cleaning process by pressing the start button (16). If
status light (15b) does not shine (C & C switches to stand-by
after ca. 10 minutes), press start button twice. Otherwise,
cleaning will not start.
Depending on your model and / or program selected, the
cleaning time takes up to 3 minutes. During this time the
status light (15b) blinks.
After cleaning and charging is completed, all indicators turn
off.
Leave the shaver in the C & C for drying. It takes several hours
until remaining moisture evaporates depending on the climatic
conditions.
Removing the shaver from the C & C
Hold the C & C with one hand and tilt the shaver slightly to the
fr
ont to release it.
Cleaning cartridge / replacement
When the level indicator (15a) lights up permanently red, the
r
emaining fluid in the cartridge is sufficient for about 3 more
cycles. When the level indicator blinks red, the cartridge
needs to be replaced – about every 4 weeks when used daily.
After having pressed the lift button (13) to open the housing,
wait for a few seconds before removing the used cartridge to
avoid any dripping. Before discarding the used cartridge,
make sure to close the openings using the lid of the new
cartridge, since the used cartridge will contain contaminated
cleaning solution.
90933746_83XX_W&D_CC&SOLO_CN-KR-ANZ.indd 4990933746_83XX_W&D_CC&SOLO_CN-KR-ANZ.indd 49 04.09.19 10:2104.09.19 10:21
Page 52 of 63
P&G RELEASE 09/04/2019 08:55:36 AM Printed 2019-09-04
To Next Page
Loading...
