Braun BNT100 - Positioning and Taking Measurements; Reading Food;Bath Temperature; Changing Temperature Scale (Fahrenheit to Celsius); Initiating Scale Change

8
3
Position
Position thermometer 0.4-2” (1- 5cm)
away from food or bath water. Be certain
to not aim at the sides of the container or
bath tub but directly at the food or water.
Aiming at the sides of the container will
inuence the reading.
Press the temperature button to take a
measurement. Device will take a reading
and you will hear a beep when the reading
is complete, unless the sound is set to
silent. If the sound is set to silent you will
not hear a beep.
Please note, it is important to keep the thermometer out of the direct line of steam
as this may cause the sensor that takes the temperature reading to collect
condensation and inuence the reading.
4
Read temperature
Remove the thermometer and read the temperature.
Please note the green backlight will be illuminated
regardless of the temperature reading in this mode.
0.4-2 inches
0.4-2 inches
1
2
How to Change from Fahrenheit to Celsius
The device is powered o.
Press and hold the speaker button,
, for 4 seconds, while the device
is o. The display will switch between
°F and °C.