10
Steam comes out from the
closure.
The closure is not tightened
correctly.
Turn off the appliance and tighten the
closure correctly, but not overtighten it.
Note: the closure might be hot.
The closure gasket is damaged.
Turn off the appliance immediately and
contact an authorised Braun Customer
Service.
Ironing system is ready,
but no steam emission from
the iron.
End of water alarm has been
reset without water refi ll.
Refi ll the water tank and press the
steam button several times for 1 minute
until pump loads water inside the
system.
Turn off the appliance and wait until it
has cooled down.
The LED
is still on although
water has been refi lled.
The reset button has not
been pressed or has not been
pressed correctly.
Make sure the reset button is pressed
correctly.
Subject to change without notice.
Please do not dispose the product in the household waste at the end of its useful life. Disposal can
take place at a Braun Service Centre or at appropriate collection points provided in your country.
5712812401_IS_5145_5155_CN.indd 10 29.05.20 11:30
To Next Page
Loading...
