To Next Page
M
meganfloydJul 27, 2025
What to do if my Braun Iron doesn't switch on?
- TTerry FosterJul 27, 2025
If your Braun Iron doesn't switch on, make sure it is correctly connected to a mains socket and then press the On/Off button.
What to do if my Braun Iron doesn't switch on?
If your Braun Iron doesn't switch on, make sure it is correctly connected to a mains socket and then press the On/Off button.
How to unscrew the closure of my Braun Iron?
If the closure of your Braun Iron is difficult to unscrew, it may be due to lime scale buildup. Turn the cap forcefully. To avoid this problem, rinse the system frequently.
Why does brown fluid leak from the soleplate of my Braun CareStyle 5 Iron?
The brown fluid leaking from the soleplate of your Braun Iron is likely due to chemical water softeners or additives that have been poured into the water tank boiler. To resolve this, never pour such products into the water tank. Clean the soleplate with a damp cloth and rinse the boiler.
What to do if there are water drops from the holes in the bottom of the soleplate of my Braun Iron?
If you notice water drops from the holes in the soleplate of your Braun Iron, it's likely due to water that has condensed inside the tubes. This often happens when steam is used for the first time or after a long period of inactivity. Press the steam button several times away from the ironing board to eliminate the cold water from the steam circuit.
Why does steam come out under the base unit of my Braun CareStyle 5?
If steam is coming out from under the base unit of your Braun Iron, the «max» pressure safety system has opened. Turn the appliance off immediately and contact an authorised Braun Customer Service.
What to do if my Braun CareStyle 5 emits an intermittent noise associated with vibrations?
This intermittent noise associated with vibrations from your Braun Iron is usually normal. It happens when water is being pumped into the boiler. If the noise persists, check if the water tank is empty and, if so, refill it and press the reset button.
What to do if I notice smoke/smell the first time I turn on my Braun CareStyle 5 Iron?
When you first turn on your Braun Iron, it's normal to notice some smoke or smell. This occurs because some parts have been treated with a sealer or lubricant that evaporates during the initial heating. This should stop after using the iron a few times. If the smoke/smell persists after turning off the appliance, contact an authorised Braun Customer Service.
Key safety warnings and instructions for initial appliance use.
Overview of the appliance's components and parts.
Specifies the correct and recommended usage for the ironing system.
Instructions for filling the water tank with tap water.
Steps to start the ironing system and heat up the iron.
Explanation of steam ironing, double trigger, and dry ironing functions.
Automatic mode suggested for wool, polyester, and cotton/linen.
Energy-saving mode for delicate garments like synthetics and silk.
How to use the precision shot for targeted steam release.
Automatic mode to reduce power consumption after inactivity.
Steps for turning off, cooling down, and storing the appliance.
Using the lock system for convenient transport and storage.
Procedure for removing limescale to maintain performance.
Instructions for cleaning the soleplate and appliance surfaces.
General| Type | Steam Generator Iron |
|---|---|
| Steam Pressure | 5 bar |
| Vertical Steaming | Yes |
| Calc Clean System | Yes |
| Power | 2400 W |
| Auto Shut-off | Yes |
| Self-cleaning | Yes |
| Anti-drip System | Yes |
| Cord Length | 1.8 m |
| Wattage | 2400 W |
| Steam Rate | 125 g/min |
| Soleplate Material | EloxalPlus |
| Steam Output | 125 g/min |
