9
Trouble-Shooting
Problem Possible reason Remedy
SHAVER
Unpleasant smell
from the shaver head.
1. Shaver head is cleaned with
water.
2. Cleaning cartridge is in use
for more than 8 weeks.
1. When cleaning the shaver head with water only
use hot water and from time to time some liquid
soap (without abrasive substances). Remove Foil
& Cutter cassette to let it dry.
2. Change cleaning cartridge at least every
8 weeks.
Battery performance
dropped significantly.
1. Shaver head is regularly
cleaned with water but not
lubricated.
2. Foil and cutter are worn
which requires more power
for each shave.
1. If the shaver is regularly cleaned with water, apply
a drop of light machine oil on top of the foil once
a week for lubrication.
2. Renew Foil & Cutter cassette.
Shaving performance
dropped significantly.
1. Shaving system is clogged.
2. Foil and cutter are worn.
1. Soak the Foil & Cutter cassette into hot water
with a drop of dish liquid. Afterwards rinse it
properly and tap it out. Once dry apply a drop of
light machine oil on the foil.
2. Renew Foil & Cutter cassette.
Cooling element is
warm.
1. Shaver was used with
cooling function a couple of
minutes before.
2. Battery capacity is too low
for the cooling function.
1. You can use the shaver like this or turn on the
cooling function and wait a few seconds until it is
activated again.
2. Charge the shaver after each shave to ensure
sufficient battery capacity for the cooling
function.
Shaver head is
damp.
1. Drying time after automatic
cleaning was not sufficient.
2. Drain of the Clean&Charge
station is clogged.
1. Clean directly after shaving to allow enough time
for drying.
2. Clean the drain with a wooden toothpick.
CLEAN&CHARGE STATION
Cleaning does not
start when pressing
the start button.
1. Shaver is not placed properly
in the Clean&Charge station.
2. Cleaning cartridge contains
not enough cleaning fluid
(display lights red).
3. Appliance is in stand-by
mode.
1. Insert shaver into the Clean&Charge station
(contacts of the shaver need to align with
contacts in the station).
2. Insert new cleaning cartridge.
3. Press start button twice.
Increased
consumption of
cleaning fluid.
Drain of the Clean&Charge
station is clogged.
– Clean the drain with a wooden toothpick.
– Regularly wipe the tub clean.
Guarantee
We grant a 2 year guarantee on the product commencing on the date of purchase. Within the guarantee
period we will eliminate any defects in the appliance resulting from faults in materials or workmanship,
free of charge either by repairing or replacing the complete appliance at our discretion.
This guarantee extends to every country where this appliance is supplied by Braun or its appointed
distributor.
This guarantee does not cover: damage due to improper use, normal wear or use as well as defects that
have a negligible effect on the value or operation of the appliance. The guarantee becomes void if repairs
are undertaken by unauthorised persons and if original Braun parts are not used.
To obtain service within the guarantee period, hand in or send the complete appliance with your sales
receipt to an authorised Braun Customer Service Centre (address information available online at
www.service.braun.com).
For UK only:
This guarantee in no way affects your rights under statutory law.
92388018_CoolTec_CEEMEA_S6-76.indd 992388018_CoolTec_CEEMEA_S6-76.indd 9 22.10.12 13:5722.10.12 13:57
To Next Page
Loading...
