To Next PageTo Next Page
Need help?Do you have a question about the Braun L918FIB and is the answer not in the manual?
General| Brand | Braun |
|---|---|
| Model | L918FIB |
| Category | Lifting Systems |
| Language | English |
Steps for installing the circuit sentry and connecting power.
Procedure for diagnosing electrical or hydraulic issues with solenoids/valves.
Diagnosing issues related to no power or circuit problems.
Diagnosing issues when power is present but lift does not operate.
Diagnosing issues when the platform does not unfold.
Diagnosing slow or jerky platform unfolding.
Diagnosing issues with automatic floor level stopping.
Diagnosing issues when the platform does not lower.
Diagnosing slow or jerky platform lowering.
Diagnosing issues with the lift's bridging feature.
Diagnosing problems with the roll stop latch unlatching.
Diagnosing issues with the outboard roll stop unfolding.
Diagnosing issues with the outboard roll stop folding.
Diagnosing problems with the roll stop latch latching.
Diagnosing issues when the platform does not raise.
Diagnosing issues when motor runs but lift does not lift.
Diagnosing slow or jerky platform raising.
Diagnosing when the platform drifts down during operation.
Diagnosing issues with floor level switching.
Diagnosing when front and rear parallel arms are not aligned.
Diagnosing issues when the platform does not fold.
Diagnosing motor issues when platform doesn't fold.
Diagnosing slow or jerky platform folding.
Diagnosing platform drift during unfold operation.
Diagnosing faulty operation of the manual backup pump.
Daily checks to perform before operating the lift.
Verifies correct lift placement and clearances within the vehicle.
Confirms all specified installation steps have been completed.
Verifies clearance during platform lowering and raising.
Confirms completion of installation details and adjustments.
