10
11
Changing the sound mode
The Braun No touch + touch thermometer allows
you to silence the beeps on the thermometer to
avoid waking a sleeping child. To activate the silence
feature, slide the switch to the silent mode position
and take a temperature reading. An icon will appear
on the screen to indicate that the thermometer is in
silent mode.
Calibration
The thermometer is initially calibrated at the time of manufacture. If this thermometer is used according
to the use instructions, periodic re-adjustment is not required. If at any time you question the accuracy,
please contact Consumer Relations.
Errors and troubleshooting
Error message Situation Solution
When 20% of battery life is left, the
display ashes the low battery warning
symbol; however, the device can still
work until the battery life has 0% left.
Replace batteries.
If the steady battery icon is the only
symbol shown on the display, the device
cannot work. The battery should be
replaced immediately.
Replace batteries.
This message displays when the
measured temperature is lower than
34 °C (93.2 °F) or higher than 43 °C
(109.4 °F) or when the room temperature
is outside the operating range of
15 °C – 40 °C (59 °F – 104 °F).
Re-measure the temperature,
carefully following the
instructions in “How to use”
section.
System error – self-check display ashes
continuously and will not be followed by
the ready beep and the ready symbol.
If error persists,
If error still persists,
Wait 1 minute until the
thermometer turns o
automatically, then turn on again.
... reset the thermometer by
removing the batteries and
putting them back in.
… please contact Customer
Service.
Blank display. Thermometer does not
have power.
Please check if the batteries
have been loaded correctly.
Also check polarity (<+> and
<–>) of batteries.
Contact customer service if
thermometer still does not
function.
English
To Next Page
Loading...
