8
9
7
To turn o
Press the power button to turn o. Device will also shut o automatically after 30 seconds of no use.
How to use the No touch setting to take a food/bath temperature
1
Remove protective cap
2
Power on
Press and release the power button once. Backlight will come
on and the start-up sequence begins.
NOTE: Make sure to remove the protective scanner cap before
taking a measurement.
3
Select food & bath
temperature mode
Press and release the food & bath
temperature mode button. A beep will
sound, the food & bath icon ( ) will be
displayed, the screen backlight will turn
blue and three dashes will show on the
screen indicating the thermometer is
ready to take a temperature.
4
Position
Position device up to 6 cm away from the bath water or food.
Note: When measuring food or bath temperature the
thermometer must be aimed directly at the food or bath
water. DO NOT aim at sides of container holding the liquids
or food. DO NOT touch liquid or food with the thermometer.
5
Take temperature
Press the temperature button (you can press and hold the button or press and
release it.) The display will show a dashed line animation while it takes a reading.
Once the reading is complete, the display will show the temperature reading.
6
Read temperature
Remove the device and read the temperature.
Changing the temperature scale
1
Open battery compartment and remove
the batteries.
2
°C / °F switch is accessible in
the battery compartment.
3
Slide switch to °C or °F to set preferred
temperature scale.
4
Replace the batteries and close the
battery door.
Celsius Fahrenheit
English
To Next Page
Loading...
