What to do if my Braun Thermometer displays a system error?
If your Braun Thermometer displays a system error, reset it by removing the battery, replacing it after one minute, and then turning the device on again. If the issue persists, please contact your authorized Service Center.
What to do if my Braun Thermometer says the battery is low?
If your Braun Thermometer indicates that the battery is low, insert a new battery.
What to do if my Braun thermoscan IRT 3030 Thermometer shows an error related to ambient temperature?
If your Braun Thermometer displays an error because the ambient temperature is outside the operating range (10–40 °C or 50–104 °F), allow the thermometer to sit for 30 minutes in a room where the temperature is within the specified range.
What to do if my Braun Thermometer shows temperature outside normal range?
If the temperature reading on your Braun Thermometer is outside the typical human range, ensure that the probe tip and lens are clean and that a new, clean, disposable lens filter is attached. Also, make sure the thermometer is properly inserted. Then, take a new temperature reading.
Why does my Braun thermoscan IRT 3030 Thermometer give incorrect readings?
If your Braun Thermometer is giving incorrect readings, it might be because the ambient temperature is not within the operating range. Allow the thermometer to sit for 30 minutes in a room where the temperature is between 10 and 40 °C or 50 and 104 °F.
How to stabilize my Braun thermoscan IRT 3030 Thermometer before taking a temperature?
To stabilize your Braun Thermometer, wait until all the icons stop flashing before taking a measurement.
What to do if my Braun thermoscan IRT 3030 Thermometer displays an ambient temperature error?
If your Braun Thermometer shows an error related to ambient temperature, it means the surrounding temperature is outside the 10–40 °C (50–104 °F) range. To fix this, leave the thermometer in a room within this temperature range for 30 minutes to allow it to stabilize.
Why does my Braun thermoscan IRT 3030 say 'Hygiene cap is attached'?
The Braun Thermometer may display this error if the hygiene cap is attached or if a measurement is attempted before the device has stabilized. Ensure the hygiene cap is removed and wait for all icons to stop flashing before taking a measurement.
Why does my Braun thermoscan IRT 3030 give a reading before it's ready?
If you are getting a measurement before the device stabilizes or the hygiene cap is still attached, wait until all the icons stop flashing.
General| Measurement Method | Infrared |
|---|---|
| Measurement Time | 1 second |
| Memory Function | Last reading |
| Display | LCD |
| Battery Type | 2 AAA batteries |
| Automatic Shut-off | Yes |
| Type | Ear thermometer |
| Measurement Site | Ear |
| Age Range | Suitable for all ages |
| Hygiene | Disposable lens filters |
| Accuracy | ±0.2°C (±0.4°F) |
To Next Page
