8
2. Put desired attachment onto
drive shaft of the bowl and push
it down as far as it will go.
3. Put the lid onto the bowl
matching the arrow on the lid
with the arrow on the bowl.
Turn the lid clockwise guiding
its nose rim into the safety lock
opening of the motor block
until it audibly snaps into place.
See figure B
4. Set the speed range by means of the variable
speed regulator. It is recommended to first
select the speed and then switch on the
appliance in order to work with the desired
speed from the beginning. See figure f
5. Fill the food processor bowl with ingredients.
Note: In order to avoid damages caused by
overload, this appliance is equipped with an automatic security switch
which shuts off the current supply if necessary. In such case, turn the
motor switch back to off «O» and wait approximately 15 minutes to allow
the motor to cool off before switching on the appliance again.
6. Switch the motor to the on position «I». See figure f.
Note: The appliance can only be switched on when the food processor
bowl and the lid is properly engaged. If the lid is opened during operation,
the motor switches off automatically. In this case the motor switch is still
on «I», turn it back to «O» to avoid switching on the motor accidentally.
REMOVING THE WORKING BOWLS
1. Switch off the appliance.
2. Turn the lid counter-clockwise and lift it off. Then turn the bowl in the
«click» direction until the arrow on the bowl matches the arrow on the
motor block and lift off the bowl.
3. When removing the blade from a bowl, take hold of it by the knob and
pull it off. Caution:The blades are very sharp!
4. The blade comes with a protective cover. If not in use, store the blade
on the protective cover.
B
click
1
2
click
f
5722010244_FP3020_US.indd 8 19.01.21 15:44
To Next Page
Loading...
Need help?
General
Weight and Dimensions
