Page 44
W
A
RNING
Risk of electrical fire!
Install and electrically
terminate Auxiliary
electrical device as
specified by device
manufacturer.
A fuse block that can accommo-
date up to six additional ATO
®
type fuses is provided behind the
dash below the steering column.
This power source is available for
installation of a dealer-installed
power seat, an electric tie-down
or other auxiliary electrical device.
The installer is responsible for
supplying the correct gauge
wire and fuse for the particular
device to be attached to the fuse
block (as specified by the
manufacturer of the device).
The maximum load must not
exceed 25 amperes. Wiring
must be routed and terminated
properly by the installer. Wires
with female fully-insulated termi-
nals can simply be connected to
one of six available terminals on
the fuse block. Note: If install-
ing an auxiliary electrical
device that requires more than
a 25 ampere power source, an
alternative power source must
be provided. Refer to the
Electrical Schematic and Wiring
Diagram contained in this
manual.
Note: A switch and power-supply
cable are supplied with each
Entervan
®
for use when installing
an auxiliary electrical device (if
applicable).
Auxiliary Power Supply
for Dealer-Installed Power Seat or Tie-Down
Troubleshooting
To Next Page
