Page 18
Operation Notes and Details
Lift Features (continued)
Inner Roll Stop
Fully-Deployed
(vertical)
Inner
Roll Stop
The inner roll stop must
overlap the threshold (base)
plate a minimum 1/2".
Fully-Unfolded
(horizontal)
Inner Roll Stop
(bridging position)
Inner Roll Stop: NL-2 Series
lift models are equipped with
an automatic inner roll stop that
also serves as the bridge plate
(inner roll stop photos below).
When the UNFOLD switch is
pressed and the platform unfolds
from stow position to oor level,
this mechanical roll stop is auto-
matically unfolded to the bridging
(horizontal) position to provide a
bridge plate between the platform
and the lift base plate (vehicle
oor). The inboard edge of the
bridge plate rests on the threshold
warning plate (base plate).
The roll stop automatically
deploys (rotates) to the vertical
(roll stop) position as the platform
lowers to the ground (DOWN
switch is pressed).
As the UP switch is pressed and
the platform raises from ground
level, the inner roll stop automati-
cally unfolds (rotates) to the
To Next Page
Loading...
