BraunAbility Simple Stow Infloor - Weekly Preventive Maintenance

Page 6
Maintenance and Lubrication Schedule
Maintenance
General preventive maintenance
cleaning and visual inspection
procedures should be performed
weekly. Inspection, lubrication
and maintenance procedures
outlined in the 5,000 mile or 6
month and 30,000 mile or 3 year
intervals sections should be
performedbyanMSEcertied
technician to correspond with
the Maintenance Guidelines and
Service Log Booklet.
Additionalrampspecicinspec-
tion, lubrication and maintenance
procedures maybe required and
should be performed in accor-
dance to the 2,500 mile or 1,000
ramp cycle intervals section.
These intervals are a general
guideline and will vary accord-
ing to frequency of use and
conditions. Exposure to severe
conditions (weather, environment,
heavy usage, etc.) may require
inspection and maintenance
procedures to be performed more
oftenthanspecied.
Inoorrampcomponentsare
accessible only by removing the
top cover. Inspection, cleaning
and lubricating procedures are
restricted.
Unlessaproblemwithaninoor
ramp has occurred, or the ramp
system is being exposed to an
extremely dusty environment or
other severe conditions, removal
of the ramp cover for routine
inspection and cleaning proce-
dures is not recommended.
If a problem with the ramp has
occurred, remove top cover
assembly as outlined in the
Ramp Cover Removal instruc-
tions.Withtheoorandcover
assembly removed, perform
the maintenance and lubrica-
tion procedures outlined in the
“5,000 miles or 6 Month Inter-
vals - ManualInoorRamp(top
cover removed)” section.
Cleanspeciedcomponentsand
the surrounding area before ap-
plying lubricants. When replac-
ing lubricated components, be
sure to lubricate during installa-
tion procedures.
A“dri-lm”styleoflightoil
should be applied where Light
Oil is called out (goes on wet
and then dries). Lubricants of
this type are available that do
not attract dust and other debris.
Use of improper lubricants can
attract dirt or other contaminants
which could result in wear or
damage to components. Avoid
lubricants that can leave stains.
Discontinue use immediately
if maintenance and lubrication
procedures are not properly per-
formed, or if there is any sign of
wear, damage, improper opera-
tion or any abnormal condition.
Contact your sales representa-
tive or call 1-800-488-0359. A
BraunAbility Customer Experi-
ence representative will direct
you to an authorized service
technician who will inspect your
vehicle.
Weekly
SimpleStowInoorrampplatform,cassette
and lower door track
Inspect for obstructions or debris such as
dirt, mud, snow, ice, etc. and clean (wipe
clean, vacuum or blow out debris using com-
pressor). Avoid blowing debris into cassette.
Resecure, repair or replace
Preventive
Maintenance