BRAX Nox4 - Initial Setup

In order to maintain the quality of this product and to ensure safe operation, we strongly recommend that our am-
pliers should be installed by an authorized BRAX-dealer. The installation by a qualied and accredited installer
will qualify you for our special lifetime warranty. Your BRAX-dealer will also assist you in selecting the correct
additional components and in ensuring that proper consideration is given to all the safety and sound related
aspects.
General instructions: Installation of BRAX ampliers
To nd out how BRAX NOX4 works best for you, read this manual carefully and follow the instructions for installation. We
guarantee that this product has been checked for proper functioning before shipping. Before you start installation, discon-
nect the car battery at the minus pole. Once again we would like to urge you to have the installation work carried out by a
specialist, as a verication of correct installation and connection of the unit is a prerequisite for warranty cover of BRAX by
AUDIOTEC FISCHER Germany.
1. Install your amplier at a dry location in the car where there is sufcient air circulation to ensure adequate cooling of
the equipment. Also ensure that there is sufcient clearance available for making the cable connections and operating the
controls.
2. For safety reasons the amplier must be secured in a professional manner. This is performed by means of four xing
screws screwed into a mounting surface. Before drilling the holes for the screws, carefully examine the area around the
installation position and make sure that there are no electrical cables or components, hydraulic brake lines or any part of
the petrol tank located behind the mounting surface - otherwise these could be damaged. You should be aware of the fact
that such components may also be concealed in the double-skin trim panels/mouldings.
General instructions: Connection of BRAX ampliers
The amplier may only be installed in motor vehicles which have a 12V negative terminal connected to the chassis ground.
Any other system could cause damage to the amplier and the electrical system of the vehicle. The positive lead from the
battery for the complete system should be provided with a line fuse at a distance of max. 30 cm from the battery. The am-
perage rating of the fuse is calculated from the maximum total current input of the car/vehicle audio system.
INITIAL SETUP
18