BRAYER BR1105 - Descaling and Cleaning Procedures

13
EN
will light up, and the illumination of buttons (18,
19, 20) will be ashing. When the buttons (18, 19,
20) illumination will glow constantly, it means that
preheating is nished.
9. Press the button (20) «
», depending on the
preset water supply time, press the button (20) «
» once or twice, ll a cup of approximately 100
ml capacity with water (it is necessary to remove
water from the boiler and ll it with citric acid
solution), if necessary, switch the water supply o󰀨
by pressing the button (20) «
» again. Pour the
liquid out from the cup.
10. Switch the water supply on by pressing the button
(20) «
» and ll a cup of about 100 ml capacity,
press the button (20) «
» again to switch the
water supply o󰀨 and pour the liquid out of the cup.
11. After a while repeat the procedure described in
the paragraph 10 and ll the cup of about 100 ml
capacity again.
12. Press the steam supply button (19) «
». Put a
suitable bowl under the tip (12) and slightly open
the steam supply by turning the knob (9) « »
counterclockwise. Carefully turn the knob (9) «
» to the maximal steam release position,
release the steam for about 1 minute, then close
the steam by turning the knob (9) « »
clockwise until bumping «•».
13. Switch the co󰀨ee maker o󰀨 by pressing the on/o󰀨
button (17) «
»,. Wait for 10-15 minutes.
Note: some water or steam may appear from the lter
holder (5), it is normal.
REMOVING MINERAL SCALE
For e󰀨ective operation of the co󰀨ee maker we
recommend removing scale every 2-3 months and when
using “hard” water more often.
1. Make sure that the power plug is not inserted into
the mains socket.
2. Make sure that the steam supply is closed. To
do this turn the knob (9) «
» clockwise until
bumping «•».
3. Make citric acid solution: 2 teaspoons of acid to 1
litre of water and pour the solution into the water
tank (15). Install the tank (15) back to its place.
4. Install the co󰀨ee lter (6) into the holder (5) having
preliminary matched the ledge on the lter (6) with
the groove on the holder (5) and turn the lter (6)
counter/clockwise to x the lter. Do not put ground
co󰀨ee into the lter (6).
5. Install the lter holder (5) into the co󰀨ee maker. The
holder (5) ledges should match the grooves on the
boiler «INSERT», after that turn the lter holder
handle (4) to the right until bumping «LOCK».
6. Place a suitable cup on the grid (2).
7. Insert the power plug into the mains socket.
8. Switch the espresso machine on by pressing the
on/o󰀨 button (17) «
», the button (17) illumination