BRAYER BR1105 - Brewing and Portion Setting

8
EN
holder (5).
• Open the lid (14) and ll the tank (15) with water, or
remove the tank (15) and ll it with water, then install
the tank (15) back to its place.
• Install the co󰀨ee lter (6) into the holder (5) having
preliminary matched the ledge on the lter (6) with
the groove on the holder (5) and turn the lter (6)
counter/clockwise to x the lter.
• Install the lter holder (5) into the co󰀨ee maker. The
holder (5) ledges should match the grooves on the
boiler «INSERT », after that turn the lter holder
handle (4) to the right until bumping «LOCK».
• Place a suitable cup on the grid (2).
• Insert the power plug into the mains socket.
• Switch the espresso machine on by pressing the on/
o󰀨 button (17) «
», the button (17) illumination
will light up, and the illumination of buttons (18,
19, 20) will be ashing. When the buttons (18, 19,
20) illumination will glow constantly, it means that
preheating is nished.
• Switch the water supply on by pressing the button
(20) «
», the pump will switch on for 25 seconds
and hot water will be poured into the cup. After
switching the pump o󰀨, pour the water out from the
cup.Preheating is over.
MAKING ESPRESSO
AFTER PREHEATING:
• Make sure that the steam supply is closed. To do this
turn the knob (9) «
» clockwise until bumping
«•».
• Remove the lter holder (5) by turning the handle (4)
to the left «INSERT» and remove the lter holder (5).
• Put ground co󰀨ee in the lter (6), slightly tamp the
ground co󰀨ee with the back side of the measuring
spoon (16).
• Install the lter holder (5) into the co󰀨ee maker. The
holder (5) ledges should match the grooves on the
boiler «INSERT», after that turn the lter holder handle
(4) to the right until bumping «LOCK».
• Wait until the buttons (18, 19, 20) illumination glows
constantly, the espresso machine is ready for
operation.
• Switch the water supply on by pressing the button
(18) « » to make one cup of co󰀨ee. The pump
will switch on and will be operating for 15 seconds.
The operation time of the pump 15 seconds is set by
default.
• To make two cups of co󰀨ee press the button (20) «
». The pump will switch on and will be operating
ATTENTION!
When making co󰀨ee do not leave the operating
co󰀨ee maker unattended, as it is necessary to watch
the cup being lled with ready co󰀨ee!