BRAYER BR1105 - Making Espresso; Espresso Preparation and Tips

7
EN
19, 20) will be ashing. When the buttons (18, 19,
20) illumination will glow constantly, it means that
preheating is nished.
Notes:
- when switching the unit for the rst time, the
buttons (18, 19, 20) illumination will be ashing
quickly, because the boiler is empty. Press the
two cups button (20) «
», the pump will be
switched on and start injecting water into the
boiler, the buttons (18, 19, 20) illumination will stop
ashing and start glowing constantly;
- the rst switching on of the pump may be
accompanied by an uncharacteristic sound, this
is a normal. After lling the boiler with water, the
sound of the pump will return to normal.
• Wait until the buttons (18, 19, 20) illumination glows
constantly, then switch the water supply on by
pressing the button (20) «
», the pump will switch
on for 25 seconds, pour the water out from the cup
and press the button (20) again «
» to switch the
water supply on again. After switching the pump o󰀨,
pour the water out from the cup.
• Repeat this procedure several times, the boiler will
be clean after that.
• To switch the espresso machine o󰀨, press the on/
o󰀨 button (17) «
», the buttons (17, 18, 19, 20)
illumination will go out.
AUTO SWITCH OFF FUNCTION
• If no actions were performed during 25 minutes
after switching on, the co󰀨ee maker will switch o󰀨
automatically.
HOW TO MAKE A GOOD ESPRESSO
• Use ground co󰀨ee for espresso co󰀨ee makers.
• Slightly tamp the ground co󰀨ee in the lter (6), you
can do it with the back side of the measuring spoon
(17).
• Co󰀨ee strength depends on the quality and grinding
degree of co󰀨ee beans. If co󰀨ee is pouring out too
long, this means the co󰀨ee powder is too ne or it is
tamped too strongly.
PREHEATING
• To make a cup of hot espresso, it is recommended to
preliminary heat up the co󰀨ee lter (6) and the lter
ATTENTION!
• Do not remove the lter holder (5) during espresso
machine operation.
• Do not remove the lter holder (5) immediately
after preparing co󰀨ee as there is redundant water
and steam pressure inside the lter (5), let the
co󰀨ee maker cool down completely.
• To remove the lter holder (5) turn the handle (4) to
the left «INSERT» and remove the lter holder (5).