BRAYER BR1105 - Getting Started: Before First Use; Initial Setup and Preparation

6
EN
and apply to the service center.
• Transport the co󰀨ee maker in the original package.
• Keep the unit out of reach of children and disabled
• persons.
COFFEE MAKER IS INTENDED FOR HOUSEHOLD
USE ONLY, DO NOT USE THE COFFEE MAKER FOR
COMMERCIAL OR LABORATORY PURPOSES.
BEFORE USING THE COFFEE MAKER
After unit transportation or storage at low
temperature, it is necessary to keep it for at least
three hours at room temperature.
• Unpack the co󰀨ee maker and remove all the
packaging materials.
• Keep the original package.
• Read the safety measures and operating
recommendations.
• Check the delivery set.
• Examine the co󰀨ee maker for damages, in case of
damage do not plug it into the mains.
• Make sure that the specications of power supply
voltage specied on the lower panel of the unit
correspond to the specications of your mains.
• Wipe the surface of the co󰀨ee maker body with a
clean, slightly damp cloth to remove dust.
• Make sure that the steam supply is closed. To do this
turn the knob (9) «
» clockwise until bumping
«•».
• Before using the espresso machine for the rst time,
wash all removable parts (1, 2, 5, 6, 12, 15, 16) with
warm water and neutral detergent, rinse and dry
them.
• Remove the water tank (15), ll it with cold water up
to the MAX mark and install it back to its place.
Notes:
- to ll the water tank (15) with water you can open
the lid (14) and pour water into the tank (15).
- to carry the water tank (15), take it by the handle
(13).
• Install the co󰀨ee lter (6) (do not add ground co󰀨ee
into the lter) into the holder (5) having preliminary
matched the ledge on the lter (6) with the groove on
the holder (5) and turn the lter (6) counter/clockwise
to x the lter.
• Install the lter holder (5) into the co󰀨ee maker. The
holder (5) ledges should match the grooves on the
boiler «INSERT», after that turn the lter holder
handle (4) to the right until bumping «LOCK».
• Place a suitable cup on the grid (2).
• Insert the power plug into the mains socket.
Note: - the buttons on the control panel (7) are
sensory, you just need to touch the button to switch the
necessary operation mode on.
• Switch the espresso machine on by pressing the on/
o󰀨 button (17) «
», the button (17) illumination
will light up, and the illumination of buttons (18,