EasyManua.ls Logo

BRAYER BR1105 - Auto Switch Off and Factory Reset

BRAYER BR1105
62 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
9
EN
for 25 seconds. The operation time of the pump 25
seconds is set by default.
Note: - watch the cup lling with the ready co󰀨ee, if
you need t switch the water supply o󰀨, press again the
button (18) «
» or the button (20) « ».
Switch the espresso machine o󰀨 by pressing the on/
o󰀨 button (17) «
», the buttons (17, 18, 19, 20)
illumination will go out.
Wait until the co󰀨ee maker cools down and remove
the lter holder (5) by turning the handle (4) to the left
«INSERT». Remove the ground co󰀨ee remnants and
wash the lter (6).
For easy removing of the co󰀨ee remnants use the
retainer on the handle (4) to prevent the lter (6) from
falling o󰀨 the holder (5).
Notes:
- the cups should be preliminary heated up, when
water heats up in the boiler, put the cups on the
tray (8).
- if you need to promptly remove the lter holder
(5), you have to reduce the pressure in the boiler,
switch the co󰀨ee maker o󰀨 by pressing the on/
o󰀨 button (17) «
», place a suitable cup under
the tip (12) and slightly open the steam supply by
turning the knob (9) « » counterclockwise.
After the pressure in the boiler is released, you
can remove the lter holder (5).
ESPRESSO PORTION SETTING
- To enter the programming mode, press and hold
the one cup button (18) « » for 3 seconds, the
button (18) « » illumination will be ashing.
Press the button (18) « » again. After the
required amount of ready co󰀨ee is poured into the
cup, press the button (18) « » again to nish
setting. Maximum time of water supply for making
one cup of co󰀨ee is 45 seconds.
- To enter the programming mode, press and hold
the two cups button (20) «
» for 3 seconds,
the button (20) «
» illumination will be
ashing. Press the button (20) «
» again. After
the required amount of ready co󰀨ee is poured into
the cup, press the button (20) «
» again to
nish setting. Maximum time of water supply for
making two cups of co󰀨ee is 90 seconds.
Notes:
- if you have programmed the water supply time
for making one cup of co󰀨ee, then the water
supply time for making two cups of co󰀨ee will be
automatically set doubled;
- water supply time for two cups of co󰀨ee can be set
up to 90 seconds. If the water supply time for two
cups of co󰀨ee was set, then the water supply time
for making one cup of co󰀨ee will be automatically
set as half the time for making two cups of co󰀨ee.
RETURN TO THE FACTORY SETTINGS
Switch the espresso machine on and wait until the

Related product manuals