BRAYER BR4955 - Before the First Use

8
EN
BEFORE THE FIRST USE
After the unit’s transportation or storage at negative
temperature, unpack it and wait for at least 3 hours
before using it.
• Unpack the unit and remove all the packaging
materials.
• Keep the original package.
• Read the safety measures and operating
recommendations.
• Check the delivery set.
• Examine the unit for damages, in case of damage do
not plug it into the mains.
• Make sure that specied specications of power
supply voltage of the unit correspond to the
specications of your mains.
• Wipe the fan body with a slightly damp cloth and then
wipe it dry.
ASSEMBLING THE FAN
• The fan is delivered with a disassembled base (1).
Do not switch the fan on without the base (1).
• Use a crosshead or at tip screwdriver (not supplied)
to assemble the base (1).
• Position the fan body (2) horizontally.
• Assemble the Base (1): join the two halves of the
Base (1) (g. 1) and secure them using 4 screws.
• Using the 4 screws, attach the Base (1) to the lower
part of the body (2) (g. 2).
• Place the fan vertically on the base (1).
Remote control (28)
ATTENTION! A lithium battery is used in the remote
control. To avoid danger, do not allow children to
play with the battery. If your child has swallowed
a battery, immediately see a doctor. Battery
installation/replacing (pic. 3)
• Press on the clamp and remove the battery holder
(29) from the remote
• control (28) body, insert a CR2025 battery (supplied
with the unit) into the holder, strictly following the
polarity.
• Install the battery holder (29) into the remote control
(28).
Notes:
- if there is an isolation insert in the battery holder
(29), remove the insert;
- replace the battery in time;
- do not recharge the lithium battery;
- remove the battery if you are not planning to use
the unit for a long time;
- remove the used battery from the remote control
(28) and dispose of it.
• When you use the remote control, direct it to the front
part of the fan body (2).
• The distance between the remote control and the fan
should not exceed 5 m, the coverage angle should
be up to 30 degrees.