BRAYER BR4955 - Using the Fan

9
EN
• Avoid exposing the receiver to direct sunlight,
otherwise false activation of control commands is
possible.
USING THE FAN
• Use the handle (6) to carry the fan.
• Place the fan base (1) on a at, dry and steady
surface.
• Do not place the fanon soft surfaces, such as carpets
with high pile, sofas or beds.
• Insert the Power Cable (7) plug into the mains.
Switching the fan on/o󰀨 and selecting the airow
speed
Notes:
- the buttons on the control panel (5) are sensory,
you just need to touch the button to switch the
necessary operation mode on;
- each pressing of buttons on the control panel (5)
or on the remote control (28) is accompanied with
a sound signal.
• To switch the fan on, press the button (8) «
» on
the control panel (5) or the button (22) «
» on the
remote control (28), you will hear a sound signal and
the fan will switch on at a medium air ow speed,
the decorative indicators (15) and the medium air
ow speed indicator (17) «
» will light up on the
indication panel (4).
• Pressing the button (9) «
» on the control panel (5)
or the button (24) «
» on the remote control (28) you
can select the air ow speed, the indicators (16, 17,
18) «
, , » will appear on the indication panel (4).
• - indicator (16) «
», low air ow speed;
• - indicator (17) «
», medium air ow speed;
• - indicator (18) «
», maximal air ow speed.
• To switch the fan o󰀨, press the button (8) «
» on the
control panel (5) or press the button (22) «
» on the
remote control (28). The fan will switch o󰀨 and after
that you can unplug the unit.
Switching the fan body oscillation on/o󰀨
• To turn the oscillation mode on, press the «
» button
(10) on the Control Panel (5) or the «
» button (25)
on the Remote Control (28), to turn o󰀨 the oscillation
mode, press the «
» button (10) on the Control Panel
(5) or the «
» button (25) on the Remote Control
(28).
Fan operation time timer
• To set the operating time of the fan, press the «
»
button (11) on the Control Panel (5) or the «
» button
(26) on the Remote Control (28) button you will hear a
sound signal, and the Timer operation time will appear
on the Display (14) «1H».