What to do if I see spider particles on the drive support plate of my Bredel APEX 10?
If you observe spider particles on the drive support plate, it indicates a damaged spider in the flexible coupling. You should check the alignment and replace the spider. Also, inspect the condition of the coupling halves and replace them if needed.
Why is there a rattling or squeaking noise near the pumphead of my Bredel Water Pump?
A rattling or squeaking noise near the pumphead suggests a damaged bare shaft kit bearing. Check the alignment. Inspect the bearing and the seal, and replace them if necessary.
Why is there a rattling or squeaking noise near the gearbox of my Bredel Water Pump?
A rattling or squeaking noise near the gearbox indicates damaged gearbox bearings. Check the alignment. Also, check the condition of the gearbox. Refer to the documentation of the gearbox for further guidance.
How to fix cyclic movement of the pumphead on my Bredel Water Pump?
Cyclic movement of the pumphead is caused by misalignment of the pumphead and drive. Check the alignment of the pumphead and drive. Verify the fixation of the pumphead and the drive to the support set, and also check the fixation of the support set components.
Information on how to use the manual as a reference for qualified users.
Contact information and required data for specific adjustments, installation, maintenance, or repair jobs.
Guidelines for enquiring about reuse or environment-friendly processing of materials.
Explanation of symbols used in the manual, including WARNING and CAUTION.
Defines the exclusive design purpose of the bare shaft set and safety remarks.
Refers to the pumphead manual for warranty conditions applicable to the bare shaft set.
Details the components of the bare shaft set, including support and kit parts.
Instructions for unpacking, checking delivery, and reporting transport damage.
General instructions for installing the bare shaft set, referring to the pumphead manual.
Step-by-step guide for mounting the support set and bare shaft kit to the pumphead.
Instructions for determining height and adjusting the drive mounting plate for alignment.
Warning about not using high-pressure spraying pistols for cleaning the pump.
Steps to isolate the drive, remove coupling guard and fasteners, and separate the drive.
Procedure for demounting the bare shaft kit, including pumphead support and line disconnection.
Steps to remove coupling half, retaining ring, key, and shaft from the hub.
Instructions for checking and preparing the bearing and seal before assembly.
Procedure for placing the bare shaft kit into the pump and securing it.
Steps for placing the drive on the support set and checking horizontal alignment.
Explains common issues like poor alignment and their impact on pumphead wobble and component lifespan.
Details components for the Support Set 10-20 and Bare Shaft Kit, including diagrams and material specifications.
Provides weights in kg for the Support set, Bare shaft kit, and Coupling.
Table of required tightening torques for steel fasteners based on metric thread size.
Specifications for flexible couplings, including dimensions and maximum displacements.
Instructions and declaration form for product use and decontamination before returning items.
General| Brand | Bredel |
|---|---|
| Model | APEX 10 |
| Category | Water Pump |
| Language | English |
To Next Page
