What to do if I see spider particles on the drive support plate of my Bredel PUMP?
If you observe spider particles on the drive support plate, it indicates a damaged spider in the flexible coupling. You should check the alignment and replace the spider. Also, inspect the condition of the coupling halves, replacing them if necessary.
Why is there a rattling or squeaking noise near the pumphead of my Bredel Water Pump?
A rattling or squeaking noise near the pumphead suggests a damaged bare shaft kit bearing. Check the alignment. Inspect the bearing and the seal, and replace them if needed.
Why is there cyclic movement of the pumphead in my Bredel Water Pump?
Cyclic movement of the pumphead is caused by misalignment of the pumphead and drive. Check the alignment of pumphead and drive. Also, verify the fixation of the pumphead and the drive to the support set, as well as the fixation of the support set components.
Guide on how to effectively use the manual for installation and maintenance.
Defines the intended use of the bare shaft set and highlights safety considerations.
General guidance and cautions for installing the bare shaft set.
Step-by-step instructions for attaching the support and bare shaft kit to the pumphead.
Procedures for mounting and aligning the drive unit with the pump assembly.
Steps for safely removing the pumphead from the support set.
Identifies common problems, their causes, and corrective actions for the bare shaft set.
Table of general tightening torques for metric thread fasteners.
General| Flow Rate | Up to 80 m³/h |
|---|---|
| Pressure | Up to 16 bar |
| Self-priming | Yes |
| Materials | Stainless steel, cast iron |
| Applications | Wastewater, mining, chemical, food and beverage |
| Drive Options | Electric, pneumatic, hydraulic |
| Power Options | Various, depending on drive option |
To Next Page
