HOW TO USE THE
SEARPLATE
TM
GRIDDLE
STEP 1
Start your re using the log cabin method, and
gradually add fuel to make a large ame. Allow the
re to burn and build a bed of coals for at least an
hour before placing the griddle onto the re pit.
STEP 2
Position the SearPlate
TM
Griddle over the re pit
once the ame tips are BELOW the re pit rim.
Using two people, lower the griddle onto the re
pit and turn the handles into a downward position.
Level the griddle by nudging the low side up with a
glove or spatula, allowing the leveling tabs to slide
along the re pit rim. Continue until the griddle is
level to the eye.
STEP 3
Allow the griddle to heat for 5-10 minutes or until
it reaches 450-500°F. Do not overheat the griddle.
We recommend starting with a low ame and
adding logs when more heat is needed.
STEP 4
Remove the SearPlate Griddle immediately after
the cook is complete. Using two people, raise the
handles and lift. Rest the griddle on the SearPlate
Stand or a noncombustible surface nearby where it
won’t be in the way or a tripping hazard.
BREEO TIP
Test the heat by doing a water test: Sprinkle
water onto the griddle, if it pops and sizzles,
you’re ready to go!
Scan to watch and
learn more about the
SearPlate Griddle.
To Next Page
Loading...