2
|
TABLE OF CONTENTS
SAFETY 3
QUICK GUIDE 4
COOLER LOCATION 6
REMOVING THE VENTURI 6
REMOVING THE TRANSITION 6
PREPARING THE DROPPER 7
MOUNTING THE DROPPER 7
SECURING THE DROPPER & TRANSITION 7
WEATHER DAMPER 8
CONVEYING THE COOLER TO THE ROOF 8
MOUNTING THE COOLER 9
CABLE INSTALLATION 9
ELECTRICAL REQUIREMENTS 10
WATER REQUIREMENTS 10
WATER MANAGEMENT 11
INSTALLING THE DRAIN VALVE 11
INSTALLING THE WATER SENSOR 11
INSTALLING THE BLEED FUNNEL ALTERNATIVE 11
INSTALLING THE INLET SOLENOID 12
INSTALLING THE FLOAT VALVE 12
MAINS WATER CONNECTION 12
INSTALLING THE VENTURI / FAN ASSEMBLY 13
ELECTRICAL CONNECTION 13
CONNECTING THE WATER PUMP 14
CONNECTING THE MAGIQTOUCH CONTROLLER
®
15
MAGIQTOUCH CONTROLLER
®
DISPLAY INFORMATION 15
SETTING THE WATER LEVEL 15
SETUP FOR BLEED FUNNEL 15
FAULT CODES INDICATED BY LED’s ON THE ELECTRONICS MODULE 16
COMMISSIONING THE COOLER 16
COMMISSIONING COMPLETION CHECKLIST 17
ADJUSTING COOLER SETTINGS 18
TROUBLE SHOOTING 19
WARNING! Failure to install and commission the product in compliance with
these instructions, or failure to do the job properly and competently, may
void the customer’s warranty. Further, it could expose the Installer and/or the
Retailer to serious liability.
To Next Page
