9. Remove top of appliance by lifting rear part and releasing it from front hooks (Fig. 3). The top is
secured to the rear panel of the appliance with a screw, which must be removed before lifting the
top and repositioned when cleaning and sanitizing operations are finished
10. Remove rear panel by extracting fixing screws (Fig. 4)
11. Remove evaporator cover panel (Fig. 5) and clean top part of evaporator, bin, evaporator cover
panel and door with water and vinegar solution
12. Remove any sediment from evaporator and evaporator cover panel using a brush with soft bristles
and a non-abrasive sponge
13. Pour plenty of cold water onto the evaporator and with the aid of the brush, direct the sediment
removed into the basin beneath, taking care not to obstruct the holes in the base of the evaporator.
During cleaning of evaporator, take care:
• not to bend coils
• not to detach water supply pipes
• not to remove evaporator thermostat
14. Open pump basin positioned on back of appliance, removing screws with a Phillips screwdriver
(Fig. 6)
15. Release pump wiring (Fig. 7)
16. Raise pump assembly, taking care not to damage wiring (Fig. 8)
17. Disconnect sprayer bank feed pipe (7) from pump, and extract from hole (Fig. 9)
18. Remove (Fig. 1) and clean with ordinary washing-up liquid:
• flag support assembly (1)
• ice-cube slide (2)
• overflow pipe (3)
• sprayer bank (4), taking care to remove side caps (5)
• sprayer bank feed pipe (7)
• pump filters (6)
19. Clean with the same washing-up liquid:
• evaporator cover panel
• inner basin
• pump basin
• immersed part of pump and bottom part of pump basin lid (8 in Fig. 9)
• bin
• door
20. Thoroughly rinse previously cleaned parts with cold water
21. Rinse and refit (Fig. 1):
• pump filters (6)
• sprayer bank feed pipe (7)
• sprayer bank (4), after repositioning side caps (5)
• overflow pipe (3)
• evaporator cover panel (Fig. 5)
22. Connect sprayer bank feed pipe to pump (7 in Fig. 9) and refit pump assembly, securing it with
screws
23. Refit panels
24. Refit the appliance in its flush-mounting installation
25. Prepare to perform the sanitizing operations described in the next chapter
3 SANITIZING
Use a 200 mg/l solution of sodium hypochlorite and water (or a solution of ½ ounce of normal bleach to
1 gallon of water) or one of the solutions commonly used to disinfect babies’ feeding bottles; in this
case, check that the sanitizing product is:
• Authorised by your country’s Ministry of Health
• Suitable for use with food machines
• Not harmful to the materials and components of this appliance
For the directions for use and concentrations, please refer to those shown on the packaging and
recommended by the manufacturer. We recommend using the solution at the temperature of 25°C.
To Next Page
Loading...
