7800-999-5456
HOW TO
OPERATE
THE PEDAL
Tip the foot pedal towards you in the “OFF”
position and toggle the ON/OFF switch into
the “ON” position. The pilot light will come
on indicating that the solid state circuit that
controls the motor is receiving power. With the
foot pedal tipped back, the wheel head should
not rotate. As the foot pedal is pushed forward,
the speed should increase smoothly, up to a
maximum of 240 rpm. If the wheel does not turn
o with the foot pedal back, or does not run fast
enough, see Troubleshooting on pages 15-17.
All wheels except the ie model are reversible.
If you wish to reverse the direction, tip the foot
pedal toward you in the “OFF” position. When
the wheel stops, move the FWD/REV toggle
switch to either Forward or Reverse.
[ On ]
[ O ]
INSTALL THE
SPLASH PAN
USING YOUR WHEEL
FOR THE FIRST TIME
NOTE: The splash pan is
not meant to hold water.
NOTE: When starting up your wheel for the rst time, the wheel may have a slight “thump”
sound. This is normal and is a result of the rubber drive belt being held in the same position
since manufacturing and should go away within 10 or 15 minutes of use.
To Next Page
Loading...