6
Operation
Manual Mode
Place hand (palm down) into the massager.
Turn the power on, select function key, and set air pressure &
heat to preference.
Power On/Off
Power On – Press and hold Power Button
Preset default is air pressure (circulating from low-high), 5 minutes
duration.
Manually operate related function buttons to switch between air
pressure and hot compress modes.
Power Off – Press and hold Power Button
*Note: After turning off the unit, allow approximately 40 seconds for
air pressure to be released. During this period, the unit will not start
when the Power ON button is pressed.
Time – Press the Time Button to select massage duration.
Heat – Press the Heat Button to select temperature (Low - High - OFF)
Air Pressure – Press the Air Pressure Button to select among three
modes (Standard - Powerful - Soft)
*Important Tip: When you feel the air pressure is too much and/or
uncomfortable, press the Pressure Reduction Valve (red button) to
release air.
To Next Page
Loading...
