Need help?Do you have a question about the Bresser 7002540CM3000 and is the answer not in the manual?
General| Brand | Bresser |
|---|---|
| Model | 7002540CM3000 |
| Category | Weather Station |
| Language | English |
Keep packaging material out of reach of children as it poses a choking hazard.
Use device as described to avoid risk of electric shock; children only under adult supervision.
Avoid contact with battery acid; rinse and seek medical attention if contact occurs.
Use recommended batteries; do not short-circuit or throw into fire.
Identifies buttons, display, battery compartment, and connections on the main unit.
Identifies wind vane, cups, antenna, radiation shield, solar panel, and battery door.
Describes the various data fields displayed on the LCD screen.
Insert main unit batteries first, place units close, and check transmission range for optimal performance.
Key guidelines for optimal sensor performance: height, location, leveling, and orientation.
Main unit automatically searches or manually initiated via [Wi-Fi/SENSOR] button.
Create account, add station, pin location, enter sensor height, name station, and get station ID/key.
Connect to station's AP, access setup interface via browser, enter Wi-Fi and station credentials.
Unit attempts to sync with internet time server automatically after Wi-Fi connection.
Set time zone, DST, hour, minute, second, and internet sync manually.
Press [MAX/MIN] to view records for outdoor/indoor temp/humidity, wind, pressure, and rain.
Press and hold [ALERT] to enter setting mode; cycle through alert types to configure.
Set alert ranges for outdoor/indoor temp/humidity and pressure drop.
Check drain hole in rain collector and ensure circular level is aligned.
Check radiation shield and sensor housing; relocate unit away from interference.
Unzip update file, copy folder to FAT32 USB stick, disconnect main unit power.
Plug USB stick, reconnect power; LCD shows status. Restart required after update.
To Next Page