33
Using the projectror and backlight
A. Battery operation:
1. When the main unit is powered by battery, press
SNOOZE/ LIGHT button (Fig. 1, 5) to turn on the projector
and backlight for approx. 5 seconds.
2. Press and hold SNOOZE/LIGHT button for approx. 4
seconds to turn on the projection for approx. 30 minutes.
During the projection, press the SNOOZE/LIGHT button
again to turn off the projection.
B. Using DC power supply*:
3. Slide the PROJECTION ON switch (Fig. 1, 15) to ON
position, the projection will be on all the time, or slide it to
opposite position to return to normal mode (Like A).
4. Slide the LIGHT ON switch (Fig. 1, 16) to ON position,
the backlight will be on all the time, or slide it to opposite
position to return to normal mode (Like A).
Note:
1. During the projection, pressing the
reverse button
(Fig. 1, 14) will reverse the projected data.
2. The rotate angle of the projector arm (Fig. 1, 2) is
approx. ±90°.
3. Adjust the sharpness of the projected data by turning
the focus wheel (Fig. 1, 4).
*not included with purchase
NOTES on Cleaning
Before cleaning the device, disconnect it from the power
supply (remove batteries)! Only use a dry cloth to clean the
exterior of the device. To avoid damaging the electronics,
do not use any cleaning fluid. Protect the device from dust
and moisture. The batteries should be removed from the
unit if it has not been used for a long time.
DE
GB
FR
NL
ES
IT
To Next Page
Loading...
Need help?
General
