Breville the Oracle Jet - Assembly

10
BEFORE FIRST USE
Machine Preparation
Remove and discard all labels and packaging
materials attached to your espresso machine.
Ensure you have removed all parts and
accessories from the box before discarding the
packaging.
Remove the water tank located at the back of the
machine unlocking the latch and pulling the water
tank from the latch handle.
Clean parts and accessories (water tank,
portalter, lter baskets, milk jug) using warm water
and a gentle dish washing liquid. Rinse well then
dry thoroughly.
NOTE
Machines with color, drip tray protection guard is
included. DO NOT DISCARD.
INSTALLING THE WATER FILTER
• Remove the water lter and water lter holder
from the plastic bag.
• Soak the lter in cold water for 5 minutes.
• Rinse the lter holder with cold water.
• Set a reminder for replacement. We
recommend to replace lter every 3 months.
• Insert the lter into the two parts of the lter
holder.
• To install the assembled lter holder into the
water tank, align the base of the lter holder with
the adapter inside the water tank. Push down to
lock into place.
NOTE
Replacing the water lter every three months will
reduce the need to descale the machine. Filters
can be purchased at www.breville.com
NOTE
Input the water hardness test strip result to the
machine. If result is 4 or 5 bars when tested, we
strongly recommend to change to an alternate
water source. Filtered water will extend both the life
of your built-in lter and descale intervals as well
as provide superior taste. Ensure to test the water
hardness of the alternative water source you've
chosen and input into the machine accordingly.
Avoid using overly ltered water, like RO water
unless some mineral content is being added back
to the nal water. Never use distilled water, or water
with no or low mineral content as this will aect the
taste of coee.
ASSEMBLY