EasyManua.ls Logo

Bri-Mar DTR510LP - Loading Bulk Material

Default Icon
146 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Loading And Unloading The Trailer
Bri-Mar 96
^ WARNING
RAISED DUMP BODY CAN DROP OR TIP OVER SUDDENLY. YOU
AND OTHERS CAN DIE OR BE SERIOUSLY INJURED.
YOU MUST:
• Have trailer on level, firm ground before dumping.
• Keep others away while dumping.
• Stay at controls until dump body is down.
NEVER LEAVE THE SCENE WHEN DUMP BODY IS LIFTED.
• Lock hoist controls after use.
• Have dump body down before moving trailer.
• Use body-prop and have dump body empty before getting under
raised dump body.
• If the hoist does not lift the load:
-Manually reduce the load - obtain service from a qualified hydraulics
technician.
NEVER ASSIST THE HOIST. (i.e., with a jack, crane, heavy
equipment, etc.
• If the load does not leave the dump body: Lower the dump body and
manually free the load.
• Never attempt to free a load from a raised dump body.
5.4.2 Loading Bulk Material
• Couple the trailer to the tow vehicle.
• Park the trailer and tow vehicle on a firm and level surface, both
side-to-side and front-to-rear.
• Check the dump body for damage. Repair before loading trailer.
• Close and latch trailer gates.
• Verify that the hydraulic pump battery is fully charged and the fuses
in the battery box are not blown. Replace fuses if blown.
• Tell the loader operator the GVWR of your trailer. The loader
operator will have an approximate weight of the material to be
loaded.
• Use common sense when loading. If you are uncertain of the weight
of the material, load a small amount and weigh your trailer. It is
Trailers

Table of Contents