Loading And Unloading The Trailer
Bri-Mar 105
Figure 5-9- Remote or Pendent Dump Controller
• Discontinue pushing the up button and walk to the rear of the trailer
so you can estimate if there is enough space for the remainder of the
load to be safely dumped. If not, then you need to fully lower the
dump body by pushing and holding the down button (2) and then
pull the trailer forward and then repeat the previous step. See figure
5-9.
• Standing well clear of the dump body, raise the dump body to the
three quarter point of the maximum dump angle. Discontinue
pushing the up button and walk to the rear of trailer to check to see if
there is enough space for continued dumping.
• Repeat the process until the load has been completely dumped.
• If the load has not completely dumped DO NOT drive forward and
stop quickly to “shock” the load out of the body. Also DO NOT
“jerk” the control button up and down to dislodge the load. The
proper procedure for a stuck load is to lower the dump and dislodge
the material by hand.
Trailers
To Next Page
Loading...