Operation and Safety Manual
Operation and Safety Manual
Model CX30E/35E Belt Driven Automatic Slicers
Model CX30E/35E Belt Driven Automatic Slicers
Replace the blade cover so that the nut on the underside of the plate engages the blade
While pressing down on the centre of the plate push and turn the blade cover securing
knob to engage it in the blade cover. Tighten the knob.
Replace the meat table and carriage assembly and tighten the securing knob.
Make sure that the edge of the meat table sits right up against the blade cover. You may
have to push the meat table back to the end of its travel to seat it correctly.
The slicer is now clean and ready for use.
How frequently the slicer is cleaned will depend on how heavily the machine is used.
However, we recommend that you adopt the following cleaning schedule as a MINIMUM
requirement to maintain hygiene.
Wipe down slicing guide,
meat table & centre plate
Wipe down all exposed
surfaces (no disassembly)
Clean all surfaces including
blade (disassemble machine)
After
every use
Before
first use
Every
half day
After
last use
To Next Page
Loading...
