Brice CX30E - Electrical Safety; Troubleshooting

Operation and Safety Manual
Operation and Safety Manual
™
Model CX30E/35E Belt Driven Automatic Slicers
Model CX30E/35E Belt Driven Automatic Slicers
10.
Lower the sharpener cover (1) .
The grinding stone (5) Should be kept clean
and free of grease for the best sharpening
performance. It can be easily removed for
cleaning. Simply pull it out of its holder as shown.
Electrical safety
The Model CX Matic 300 and 350 are both  tted with safety cut-out switches that will
automatically stop the machine if, while running: the blade cover is removed; the sharpener
cover is lifted; or if there is a sudden power drop. If any of these events occurs, either
replace the relevant component or wait for power to be restored and switch the machine
back on.
Maintenance 4.3
5
1
Indication
Problem
Problem Problem
Solution
Machine does not operate
Poor/no electrical current
Fuse blown (if  tted)
Other parts fo machine
are defective
Notify Brice service
Replace fuse
Notify Brice service
Machine slices poorly
Blade is not sharp enough
Sharpen the blade
Carriage does not run
smoothly
Slide bar requires oiling
Notify Brice service
The meat grip does not
slide smoothly
The meat grip is dirty or
requires oiling
Clean and oil meat grip
slide bar
Blade stops rotating whilst
slicing meat
Motor drive belt is loose
or broken
Notify Brice Service
Motor runs but blade does
not rotate
Motor drive belt is
cracked or broken
Notify Brice Service
Troubleshooting
This section deals with the problems you may  nd when using the Model CX Matic, and the
methods and procedures for solving them quickly and easily.
Mechanical or electrical problems during operation