Page 32
6 WORKPIECE SETTING
When using a manually tightened fixture, always remove the clamp handle or
tightening tool from the fixture after tightening.
When clamping a workpiece on the table or in the fixture, take note of the
rigidity of the workpiece.
Make sure that the workpiece will not be loosened or distorted due to the
clamping force.
Do not leave articles such as tools and rags inside the machine. If the machine
is operated with such articles inside it they may become entangled with a tool
and thrown out of the machine, and this could cause serious injuries or damage
to the machine.
This Machining Centre is designed to machine non-hazardous metals only.
To Next Page
Loading...
