Briel CHAMONIX ES35A - Making Tea; Cleaning and Maintenance

7. MAKING TEA
8. CLEANING AND MAINTENANCE
28
If you need to produce some more steam:
· When the temperature OK indicator light glows, repeat all the steps above indicated.
Milk residues, when dr
y, can damage the cappuccino nozzle. You must clean it after each use. To
do it, remove it and rinse it well.
And you can make TEA as well!
Preparing the appliance:
· Remove the water tank by pulling it outward and fill it with cold water (water tank can also be
filled by raising the cover lid);
· Insert plug into a wall outlet;
· Turn the machine ON. The power ON indicator lamp will light;
· When the machine is ready, the temperature OK indicator lamp will light;
· Place the cup with the tee bag inside under the cappuccino nozzle.
· Open the steam control , and turn the coffee function ON. Water immediately drops from the
cappuccino nozzle.
· When you reach the desired quantity of water, turn off the coffee function, and close the steam
control.
· Clean the cappuccino nozzle each time after you have immersed it in milk; otherwise the inside
of nozzle and air intake holes become clogged and milk deposits on outside harden and are difficult
to remove.
To clean – hold wet cloth very close to tip of nozzle and open steam control. Let steam
escape into the cloth for one or two seconds to clear out nozzle. Wipe outside of nozzle.
Clean by soaking in hot water, then replace. If necessary, use a needle to clean air intake holes on
side of frother.
· No Briel parts should be placed in the dishwasher. This will cause distortion and may result in the
parts not functioning properly or safely;
· From time to time, remove lower section of frother by holding upper part and unscrewing lower
part. Clean carefully and reassemble;
· Clean filter-holder and coffee filters with water after each use;
· Remove drip tray and grid and wash with warm water. Use sponge to clean out drip area;
· Ground coffee will adhere to the seal inside of the brew head. Keep it clean;
· When the machine is not in use for a long period, drain stale water from machine by turning the
coffee function ON. However, do this only after you have filled reservoir with fresh water. Never
operate pump unless there is water in the machine;
· Wash Cremaker filters and the filter-holder regularly;
· The water tank and the drip tray can be removed for an easier cleaning;
· The cappuccino nozzle can be removed from the steam tube for cleaning.
Descaling:
It is advisable to descale the appliance every 4- 6 months, depending on the hardness of the water
and the frequency of use.
· Fill the water tank with a 50% water, 50% vinegar solution;
· Place a recipient under the brew head without filter-holder;
· Turn ON the coffee funtion and let most of the solution flow to a recipient;
· Turn OFF the coffee function, put the recipient under the Cappuccino nozzle and open the steam