What to do if my Brigade MDR-644-0.5-SSD Measuring Instruments experience system power loss?
If your Brigade Measuring Instruments are experiencing system power loss, consider the following: The vehicle battery should be replaced if it is suspected of malfunctioning. Ensure the low voltage protection feature is turned on. Check if any fuses are blown and replace them if necessary.
Why am I experiencing video loss with my Brigade MDR-644-0.5-SSD Measuring Instruments?
If you're experiencing video loss with your Brigade Measuring Instruments, make sure cables are not installed in areas where they can be tampered with. Also, ensure cable connectors are secure before driving.
How to fix no recording on SD or HDD/SSD issue with Brigade MDR-644-0.5-SSD Measuring Instruments?
To fix a 'no recording' issue on your Brigade Measuring Instruments, ensure that the overwrite feature is turned on. Additionally, consider installing a larger capacity HDD/SSD or a 256GB SD card.
How to troubleshoot docking station failure in Brigade Measuring Instruments?
To troubleshoot docking station failure in your Brigade Measuring Instruments, ensure the MCU key is locked and that wires being used are protected by heat shrink.
What to do if Brigade Measuring Instruments fail due to environmental conditions?
If your Brigade Measuring Instruments fail due to environmental conditions, the driver should wait a few minutes for the internal heater to heat the HDD to above 10°C. The device will then start to record.
General| Brand | Brigade |
|---|---|
| Model | MDR-644-0.5-SSD |
| Category | Measuring Instruments |
| Language | English |
Wiring and connection diagram for the MDR-641XX model.
Wiring and connection diagram for the MDR-644XX model.
Covers fundamental settings like vehicle registration, time, and power.
Configuration for date format, time zone, and daylight saving.
Settings for power modes (Ignition, Timer), voltage, and sleep.
Configuration options for network connectivity (Ethernet, Wi-Fi, etc.).
Settings for live viewing and recording management.
Configuration for live video display, including preview and OSD.
Details on preview settings for live video.
Customization of information displayed on the live video feed.
Settings for recording parameters, modes, and storage.
Settings for resolution, frame rate, and quality for HDD recording.
Settings for sub-stream recording parameters to the SD card.
Settings for configuring various alarm types and triggers.
General alarm configuration and audio settings.
Configuration for Input/Output alarms and trigger sources.
Setup for linking alarms to outputs and audible alerts.
Settings related to video alarms, including video loss.
Configuration for detecting and alerting on video signal loss.
Configuration for alarms related to HDD or SD card malfunctions.
Procedures for system maintenance, upgrades, and data export.
Procedures for managing configuration files for the MDR.
Instructions on how to perform firmware and software upgrades.
Options for formatting and managing storage media like HDD and SD.
A quick guide on how to retrieve data from HDD using MDR-Dashboard.
Step-by-step instructions for installing the MDR-Dashboard software.
Procedures for connecting the MCU to a PC for data transfer.
Procedures for system maintenance, testing, and inspection.
Solutions for common issues encountered with the MDR unit.
To Next Page
