To Next PageTo Next Page
Need help?Do you have a question about the Briggs & Stratton 10KW and is the answer not in the manual?
General| Fuel Type | Gasoline |
|---|---|
| Voltage | 120/240V |
| Frequency | 60 Hz |
| Rated Wattage | 10000 W |
| Starting Wattage | 12500 W |
| Outlets | Four 120V 20A Outlets, One 120/240V 30A Locking Outlet, Two USB Ports |
| Starting Method | Electric Start |
| Engine Type | 4-Stroke OHV |
| Power Output | 10, 000 watts (10 kW) |
Explains the meaning of safety alert symbols and signal words.
Details hazards associated with lead-acid batteries, including explosive gas and caustic fluid.
Warns about the danger of odorless, colorless, poisonous carbon monoxide gas.
Highlights risks of electrocution from improper grounding and backfeed to utility workers.
Warns about high engine and muffler temperatures causing severe burns.
Details the extreme flammability and explosiveness of propane and natural gas.
Advises against tampering with speed and exceeding capacity.
Warns against improper use, moisture, dust, and inserting objects into slots.
Provides guidance for homeowners and contractors on installation.
Guides owners on factors affecting installation cost and satisfaction.
Guides fuel selection, quality, and safety precautions.
Discusses optimal placement and its impact on installation.
Specifies minimum clearances from combustible material and building openings.
Emphasizes the importance of identifying essential circuits for generator load.
Guides on calculating total wattage and considering motor starting surge.
Instructs to inspect generator for damage upon delivery.
Lists all items included in the generator shipment.
Identifies key components and their functions using an illustration.
Describes the function of controls like AUTO/OFF/MANUAL switch, circuit breaker, and diagnostic LED.
Names the four access doors and explains how to remove them.
Provides steps for installing access doors correctly.
Warns about severe burns from hot exhaust ports and surfaces.
Details initial engine oil check, usage, and maintenance.
Explains battery connection, trickle charge, and fuse installation timing.
Emphasizes checking fuel connections for tightness, security, and leaks.
Guides on selecting and verifying automatic operation mode.
Details servicing safety and programming the weekly system exercise cycle.
Lists technical specifications for the 10.0 kW model.
Lists technical specifications for the 12.0 kW model.
Explains system operation, fault codes, and reset procedures.
Details causes and remedies for low oil pressure, engine fail, overspeed, and high oil temp.
Describes causes and solutions for low battery voltage, low voltage, and low frequency faults.
Provides advice on keeping the unit clean and checking for obstructions.
Outlines the process for changing and filling engine oil.
Lists information for factory contact and storage precautions.
Addresses no AC output, bogging down, and rough running problems.
Provides solutions for starting issues, engine shutdowns, and power loss.
