3
3
DISASSEMBLE CARBURETOR
1. Remove two screws and float bowl.
a. Discard O-ring.
Fig. 4 − Remove Float Bowl
FLOAT
BOWL
2. Disassemble fuel solenoid from float bowl. Discard gas-
ket.
a. Use 1/2” thin profile wrench and carburetor socket,
Tool #19458 (14 mm) or 19459 (16 mm).
b. Remove fixed main jet.
Note: Use care when removing solenoid to prevent
damage to fixed main jet and housing.
Fig. 5 − Remove Fuel Solenoid
MAIN JET
MAIN JET
HOUSING
SOLENOID
3. Remove float hinge pin, float and inlet needle.
4. Remove emulsion tube body and gasket.
Discard gasket.
Fig. 6 − Remove Float
EMULSION
TUBE BODY
INLET NEEDLE
FLOAT
Fig. 7 − Remove Cover Plate
COVER
PLATE
Remove cover plate. Discard gasket.
To Next Page
Loading...
