Briggs & Stratton Generator User Manual

Questions? Help is just a moment away!
Preguntas? La ayuda es justa un momento
lejos!
Vous avez des questions? Vous n'avez pas
besoin d'aller loin pour trouver de l'aide!
Call: Home Standby Generator Helpline
Llamada: Línea Directa de Reserva de Hogar
Appelez: Ligne Directe de Secours À la
Maison - 1-800-743-4115 M-F 8-5 CT
Web: www.briggspowerproducts.com
Models 01897-0 Part No. 194943GS Rev. 3 (08/03/05)
Installation,
Start-Up and
Owner’s Manual
Manual de Instalación,
Arranque y Propietario
Manuel d'Installation,
Démarrage et Utilisateur
Home Standby Generator

Briggs & Stratton Generator Specifications

General

Brand	Briggs & Stratton
Model	Generator
Category	Portable Generator
Language	English

Summary

Important Safety Instructions

Installation Guidance

Control Panel Overview

Installation Procedures and Requirements

Generator Placement and Handling

Lifting and Generator Clearances

Details safe lifting practices and required clearances for operation.

General Location Guidelines

Essential Circuits and Load Management

Selecting Essential Circuits for Standby Power

Gaseous Fuel System Installation

Gaseous Fuel System Details

Fuel Pipe Sizing Charts

Wiring, Connections, and Pre-Start Checks

Grounding and Control Circuit Connections

Before Initial Start-Up: Engine Oil

Engine Oil Type and Checks

Details engine oil type and checks required before starting the generator.

Battery and Fuel System Setup

Battery Connection and Servicing

Fuel Supply System Requirements

Ensures fuel lines are tight, secure, and adequate pressure is available.

Fuel System Selection and Initial Start-Up

Fuel System Selection for LP or NG

Guides conversion and configuration for propane or natural gas fuel.

Initial Start-Up Procedure (No Load)

Step-by-step process for testing the generator without electrical load.

Automatic Operation Sequence Explained

Utility Voltage Sensors and Timers

Setting Exercise Timer and Installation Inspection

Setting the Generator Exercise Timer

Final Installation Inspection Checklist

Generator Specifications and Operation Modes

Automatic Operation and Testing

Fault Detection System Overview

Fault Detection System Details and Troubleshooting

Fault Codes and Reset Procedure

Lists fault codes and explains how to reset the system.

Troubleshooting Specific Faults

Covers low oil pressure, engine start failure, low frequency, and overspeed issues.

Generator Maintenance Procedures

Changing Engine Oil and Filter

Step-by-step guide for performing oil and filter changes.

Changing Oil

Detailed procedure for draining and refilling engine oil.

Changing Oil Filter

Troubleshooting Common Problems

System Schematic Diagram

Wiring Diagram Details