What to do if my Briggs & Stratton Portable Generator engine will not start?
If your Briggs & Stratton Portable Generator engine won't start, it could be due to several reasons: * A missing or blown 15 Amp fuse. Install a new 15 Amp fuse. * The fuel supply being turned off or depleted. Open the fuel valve(s) and check the propane tank. * A failed battery. Replace the battery.
What to do if my Briggs & Stratton Home Generator has no AC output?
If your Briggs & Stratton Portable Generator's engine is running but there's no AC output, the issue might stem from: * An open or defective circuit breaker. Try resetting or replacing the circuit breaker. * A fault in the generator itself. Contact a local service facility for assistance. * Poor wiring connections or a defective transfer switch. Check and repair the wiring.
Why does my Briggs & Stratton Portable Generator bog down when a load is connected?
Your Briggs & Stratton Portable Generator may bog down when loads are connected due to: * A short circuit in a connected load. Disconnect the shorted electrical load. * The generator being overloaded. * A shorted generator circuit. In this case contact a local service facility. * Incorrect fuel pressure. * An incorrect natural gas fuel mixture. * A kinked fuel line between the regulator and the engine. Remove the kink in the fuel line, and replace the line if necessary.
General| Brand | Briggs & Stratton |
|---|---|
| Model | Home Generator |
| Category | Portable Generator |
| Language | English |
Guidance for owners to communicate with installers.
Information for owners on satisfactory installation.
Explains power reduction due to altitude/temperature.
Explains the impact of physical location on installation.
Specifies minimum distances for safe generator placement.
Inspecting the generator and transfer switch for damage.
List of items included with the Home Generator System.
Engine oil shipped with the generator.
System uses synthetic oil, no break-in needed.
Unit has a 12V DC 18 Ah sealed battery.
Ensuring fuel connections are secure and leak-free.
Explains the three positions of the AUTO/OFF/MANUAL switch.
Procedures to check proper automatic operation.
Steps to disable the transfer system for maintenance.
Explanation of the timer that exercises the system weekly.
Model, power, current, voltage, frequency, phase, etc.
Maximum circuits, load, and watts.
How to reset the fault detection system after a fault.
Procedure for changing the engine oil.
How to clean the exterior of the generator.
Information needed when contacting the factory.
Information on storing the generator system.
To Next Page
