EasyManuals Logo

Briggs & Stratton Q45 User Manual

Briggs & Stratton Q45
20 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #10 background imageLoading...
Page #10 background image
10
Changing Oil
Change oil after first 5 to 8 hours of use, then every 50
hours or every season. Change oil every 25 hours when
operating the engine under heavy load or in high
temperatures.
[1] Run engine until it runs out of fuel. Otherwise, fuel
can leak out, creating a fire/explosion hazard,
when you tip engine in Step 4.
[2] Disconnect spark plug wire and keep it away
from spark plug.
[3] With engine OFF but still warm remove dipstick.
[4] Top oil drain, keep spark plug side up. Bottom or
side oil drain (if equipped), keep engine level.
Drain oil into appropriate receptacle.
Note: Top oil drain is recommended method,
however oil can drain from side (if equipped) or
bottom as shown.
[5] Place engine level. Add about (18 ounces: 0.5
liter) new oil. Fill to FULL line on dipstick. Do not
overfill. Replace dipstick.
Used oil is a hazardous waste product. Dispose
of used oil properly. Do not discard with
household waste. Check with your local
authorities, service center, or dealer for safe
disposal/recycling facilities.
CAUTION
On bottom oil drain, DO NOT rotate blade or
any other parts unless spark plug wire is
disconnected from spark plug.
DRAIN
PLUGS
PIPE
3/8”
SQUARE
WARNING
RATCHET
AND
EXTENSION
CUTTING
BLADE
OIL DRAIN
PLUG
Low Oil Fill
(if equipped)
High Oil Fill
(if equipped)
Side Oil Drain
(if equipped)
Top Oil DrainBottom Oil Drain
SPARK PLUG

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Briggs & Stratton Q45 and is the answer not in the manual?

Briggs & Stratton Q45 Specifications

General IconGeneral
BrandBriggs & Stratton
ModelQ45
CategoryEngine
LanguageEnglish

Related product manuals