EasyManuals Logo

Briggs & Stratton Quantum Snow Operating And Maintenance Instruction

Briggs & Stratton Quantum Snow
8 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #4 background imageLoading...
Page #4 background image
,
-
~..
.
engine in enclosed area, even if doors or
Install and maintain in working order aspark arrester before using
equipment on forest
-
covered, grass-covered, brush-covered
unimproved land. The state of California requires this (Secbon 4442 of
the California Public Resources Code). Other states may have similar
laws. Federal laws apply on federal land.
~:ORII?ING
ADJUSTMENTS
QR
REIJAIRS
Disconnect spark plug wire and keep it away from spark plug.
WHEN
TESTING
FOR SPARK
.
Use approved spark plug tester.
Do not check for spark with spark plug removed.
OIL RECOMMENDATIONS
CAUTION:
Engine shipped from Briggs
&
Stratton !@@&oil. Before stamina engine, fill with
oil. Do not over
-
fill.
Jse
a
h~gh qua1 ty detergent oli dassltied'for Sew ce SF,
SG,
SH.
SJ"
or nlgner
such as Br~aas
&
Stradon 30. Part Nlmoer 130005 Use no smd aoall!lcq aft*
rmmmeniid oils. Do not
mix
oil
with
aasoline.
Choose the SAE
viscosih/ grade of oil from this chart that matches the starting
temperature anticipated before the next oil change.
I
CAUTION:
A
r
coo ed englnes run notter tnan automohe englnes Tne
.sc
ol oon ?ynlnetlc mull1 wscosny o Is
(stA:
30, 10W-30, ctc
J
n temperatJres
doo#e 40
F
14 CI all1 rcs~ll in n
at
er
tbm
normal
01
consumot on When
using a multi-viscosity oil, check
oi lewd more frequently.
*
CAUTION: Synthetic oil must
be
used
when operating engine under
40"
F
(4"
Cl or enoine damaoe will occur.
I
,
,
"
CAUTION: SAE 30 oi.
fused
below 50. F (10'
C),
wll resull
ii
naro stan ng
ano pcssio
c
eoplnr! oore damaqe 0.e to nadequatc lubr~catioo.
Oil Capacity
.
Models 120000 1150000 is 0.6 It (21
02).
Models 200000
i
210000 is 0.8 It
(28
02).
.
Check oil level before starting the engine.
Check oil level before every use.
Keep oil level at FULL.
@
OIL
PROCEDURE
1.
Place engine level and clean around oil
fill
O.
2. Remove dipstick
Q,
wipe with clean cloth, insert and tighten down again.
Remove dipstick and check oil level. Oil should be at FULL mark
O.
If oil is
required, add slowly.
Do
not over fill.
-0R-
3.
Remove oil filler plug
0.
Oil should be full to overRowing
O.
4.
Tighten dipstick or oil filler plug firmly before starting engine.
FUEL RECOMMENDATIONS
Use clean, fresh.
@&keg
gasoline with a minimum of
85
octane. Leaded
gasoline may be used if
it
is commercially available and
it
unleaded is
unavailable.
In U.S.A. leaded gasoline may
not
be used. Some fuels, called oxygenated or
reformulated gasolines, are gasolines blended with alcohols or ethers. Excessive
amounts of these blends can damage the fuel system or cause
performance
problems. If any undesirable operating symptoms occur, use gasoline with a
lower percentage of alcohol or ether.
2

Other manuals for Briggs & Stratton Quantum Snow

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Briggs & Stratton Quantum Snow and is the answer not in the manual?

Briggs & Stratton Quantum Snow Specifications

General IconGeneral
BrandBriggs & Stratton
ModelQuantum Snow
CategoryEngine
LanguageEnglish

Related product manuals