Briggs & Stratton Simplicity Axion CZT2142 User Manual

28
SERVICE AIR FILTER &
PRE-CLEANER - 18.5 & 21 HP
ENGINES
NOTE: Air filter configuration may differ from shown.
Consult engine manual for further information.
Interval: Pre-Cleaner: Every 25 hours or as required.
Air Filter: Every 50 hours or as required.
Replacement Interval: Pre-Cleaner: As required. Air
Filter: Every 200 hours or once per season.
Air Filter Removal & Installation
1. Lift up on the bottom of the latch (A, Figure 37 or 38)
and flip the latch away from the cover.
2. Remove the cover (B). Remove the filter (C, Figure
38) and pre-cleaner (D).
3. Install the pre-cleaner (D) with the mesh side up.
Install the filter (C) as shown.
4. Install the cover (B, Figure 38) making sure the tabs
are inserted into their slots. Secure with the latch (A).
1.
2.
3.
Figure 37. Air Filter Assembly - Briggs & Stratton
Single Cylinder Models
A. Air Filter Latch
B. Air Filter Cover
A
B
A
B
A
B
Figure 38. Air Filter Service - Briggs & Stratton
Single Cylinder Models
A. Air Filter Latch
B. Air Filter Cover
C. Air Filter
D. Pre-Cleaner
A
C
D
B
Not for
Reproduction

Briggs & Stratton Simplicity Axion CZT2142 Specifications

General

Engine Manufacturer	Briggs & Stratton
Engine Cylinders	2
Fuel Type	Gasoline
Number of Blades	2
Transmission Type	Hydrostatic
Horsepower	21 HP
Cutting Width	42 in. (106.7 cm)
Seat Type	High Back
Tires Rear	20 x 10.00-8
Deck Material	Steel
Warranty	3 years