Need help?Do you have a question about the Briggs & Stratton Vanguard 380000 and is the answer not in the manual?
General| Displacement | 627 cc (38.3 cu in) |
|---|---|
| Compression Ratio | 8.5:1 |
| Fuel Type | Gasoline |
| Cooling System | Air-cooled |
| Engine Type | V-twin, OHV |
| Power Output | 18 hp (13.4 kW) |
| Ignition System | Electronic |
| Starter Type | Electric |
| Lubrication | Full Pressure Lubrication |
| Weight | 85 lbs (38.6 kg) |
Explains safety alert symbols, signal words, and general warnings for engine operation.
Identifies and illustrates major engine components such as oil cap, dipstick, starter, and carburetor.
Covers safe practices for adding fuel, starting, operating, and transporting equipment with fuel.
Details hazards like kickback, rotating parts, carbon monoxide, heat, sparking, and eye protection.
Covers oil pressure switch, LPG/NG engine starting differences, and initial checks.
Step-by-step guide for starting all engines, including manual and electric starter methods.
Instructions for stopping the engine using manual or electric starters and related warnings.
Action to close the fuel shut-off valve for safe transportation.
Details engine oil capacity, recommended types, and procedures for checking and adding oil.
Procedure for draining, refilling, and disposing of used engine oil.
Instructions for changing the oil filter and understanding oil pressure indications.
Guidance on using gasoline, LPG, and NG fuels, including proper fueling procedures.
Addresses issues like starter handle problems, engine not starting, smoking, or running rough.
Presents a table outlining maintenance tasks and their recommended intervals (hours/daily).
Details cleaning and installation of air cleaner components with and without a fuel tank.
Instructions for checking, cleaning, gapping, and replacing the spark plug.
Guidance on cleaning engine debris, air cooling system, and muffler areas.
Procedures for replacing the fuel filter and checking valve clearance.
Provides instructions for preparing the engine for storage, including fuel management.
Information on obtaining service from authorized dealers and a list of genuine parts.
Details specifications for different model series, including bore, stroke, and displacement.
Provides information on engine power ratings and emission compliance standards.
Details the warranty coverage for emission control parts and its provisions.
Outlines the owner's responsibilities for maintenance and warranty claim procedures.
Summarizes the limited warranty terms and coverage periods for different product lines.
Lists conditions and causes of engine failure that are not covered by the warranty.
To Next Page
